Bunny Brew-Archived

Flavor: Hoppy
ABV (alc/vol): 4.5%
SRM (Color): 5
IBU (Bitterness): 22

ABV -- An estimate of alcohol content given in percent of alcohol by volume. Your actual abv may vary.

SRM -- Color based on Standard Reference Method, where as:
- Pale Beers are between 0 - 6
- Amber Beers are between 7 - 13
- Dark Beers are 14 - 20
- Black Beers are 21 and over
(fruits may add additional color.)

IBU -- Bitterness shown in International Bittering Units, where:
- Low bitterness 0 - 20
- Moderate bitterness 21 - 30
- Noticeable bitterness 31 and over

Bunny Brew-Archived

Pale in color, with a light spicy finish, Bunny Brew is full of hops. Goes well with braised rabbit, or anything cooked over an open flame.

RECIPE INGREDIENTS:
1 Can West Coast Pale Ale HME
1 Can Pale Export UME
1 Packet Dry Brewing Yeast (under lid of HME)
1 Packet Palisade Pellet Hops
1 Muslin Hop Sack
1 Packet No-Rinse Cleanser



Step 1: Sanitizing
Follow the steps outlined in the Instructions that came with your kit.

NOTE: Be sure to sanitize your hop sack along with all your other equipment.



Step 2: Brewing
2.1. Fill keg with cold water to the 4-quart mark on the back.

2.2. Remove yeast packet from under lid of HME, then place unopened cans of HME and UME in hot water to make the liquid easier to pour.

2.3. Place 1 packet (1/2 oz.) of Palisade pellet hops into the hop sack tying it closed, then trim away excess material.

2.4. Using the sanitized measuring cup, place 4 cups of water into a clean 3-quart pot and bring to a boil, then remove from heat.

2.5. Stir HME, UME and hops (in hop sack) into this water. This mixture is called the wort.

NOTE: Hops appear as green leaf particles and do not dissolve. Keep hops in fermenter the entire fermentation period.

2.6. Pour wort into keg. Bring the volume of the keg to the 8.5-quart mark by adding more cold water. Stir vigorously to mix well.

2.7. Sprinkle yeast into keg and allow to sit for 5 minutes. Stir vigorously again, then screw on lid.

2.8. Ferment by placing the keg out of direct sunlight and in a location with a consistent temperature. Allow beer to FERMENT A MINIMUM OF TWO WEEKS at room temperature (between 68°-76°F).



Step 3: Bottling & Carbonating
Follow the steps outlined in the Instructions that came with your kit.

TIP: For best results allow to lager for at least 2 to 4 weeks.

1-Liter Deluxe Bottling System (Qty 8) $13.95 AVAILABILITY: In stock!		16 oz. Glass Swing-Top Bottles (Qty 12) $29.95 AVAILABILITY: In stock!
Professional Bottling System $35.87 AVAILABILITY: In stock!